Content → Command Stations → Digitrax LocoNet

• Command Stations | Interfaces | Devices | Wiring

• Setup | DCS100/200 DB150 | DCS50 Zephyr | IntelliBox | Slot Server

• LocoNet devices are not reported using the p50/p50x protocol.
• Using the LocoNet protocol all devices on the LocoNet bus are accessible.
• Support is excluded because the IB does behave not conform the LocoNet specs.

Manufacturer	Uhlenbrock / Modeltreno
Product info	http://www.uhlenbrock.de
Description	The intellibox is a full featured command station. It has a build in RS232 interface that can be operated in a "LocoNet" mode. Than it behaves similar to a LocoBuffer.

1. Upgrade the software inside the Intellibox to at least version 1.500: http://www.uhlenbrock.de
2. Put the interface into mode "LocoNet":
   • Basic settings → interface → syntax → LocoNet
3. Set baud rate to 19200 Baud:
   • Basic settings → interface → bit per second → 19200 bit/s
4. Set the UART of the interface to 1 stop bits: (default 2)
   • Basic settings → special option → SO 5 → 1
5. Disable SO 6: (default 254)
   • Basic settings → special option → SO 6 → 0

Additonal Info: ib-so.pdf