Normaler Text, wie er im Wiki verwendet wird.

Kleiner geschriebener Text (85%) als Einschub. Hier können spezielle Details erläutert werden, die nicht in allen Fällen relevant sind.

After starting Rocview, create a new or open an existing workspace as described in chapter 2.0 of the step-by-step instructions.
Prepare adding the command station as described in chapter 3.0

After the virtual command station was deleted according to the instructions linked above, select mbus from the drop-down menu New. The slected command station is added by pressing Add.
A new command station with Interface ID NEW and controller mbus is displayed in the list. After selecting (clicking on) this entry and clicking on Properties a new dialogue opens.
The Interface ID NEW should be overwritten by an appropriate individual name, e.g. CS3 or CS-3. The Type has to be set to TCP. The Hostname is the IP address of the CS2/CS3 and has to be entered here. After the colon add 15731 as communication port.
Device, Baudrate and CTS should stay unchanged. Protocols not required can be unchecked, if necessary.
After closing both the mbus dialogue and the properties dialogue with OK Rocrail has to be restarted.

To check the configuration after the restart, the workspace that was edited before is opened again. With the CS2 / CS3 started and in Stop mode track power can be switched on and off by the lightbulb symbol in the tool bar. If the command station responds to this test, the setup is complete.
Additional check: After opening Menu → Programming → CANBUS the CS and the GFP should be displayed in the list.