Signal Decoder Type
Introduction
The Decoder Type is targeted to special aspect decoders like WeichZwei-Decoder.
Up to 16 addresses can be handled by Aspect Values.
The control is by output commands which are switched on for a duration of 100ms, which can be increased by the Command time.
Interface
Protocol
Select the target protocol, for example "NMRA-DCC".
RED
The base address of the decoder.
Control
- Aspect numbers
Type
- Decoder
Details
This example uses 5 aspects:
plan.xml.zip
Aspects
For this example 5.
Number
The range of 0…4 should be set. The order is free and is user dependent.
Value
This example shows the value for the first aspect of this example.
