ServoSet
 |  |
| By Peter Giling |
|---|
Directions for construction
This mounting support makes installation under the table very easy.
The set is complete delevered with seromotor, 2 and 3mm bolts, nuts , bushes and washers.
Mounting is very simple, as display on pictures below.
| Fix 3mm bolt with 2 nuts on top of each other at left hand side and 2mm bushes middle and right. Do not forget 2mm washers ! |  |
| Drill 2mm hole in the plastic lever (2nd or 3rd hole from the middle) and fix nylon bush with 2mm bolt and nut |  |
| Fix moving board on top, and fix it with washer and 3mm self locking nut/. Be sure that board is solid fixed but still easy moving. |  |
| Fix motor with 2mm screws as shown |  |
| Next, the spring wire can be fixed in any of the 56 holes. Is is better not to solder this wire, but just slip it through a few holes to fix it securely. |  |
List of parts
The following parts are available as set from Giling Computer Applications