RocNetNode Turntable Multiport

Content → Command Stations → RocNet

• RocNet Protocol | RocNetNode
  • RocNetNode Setup | RocNetNode Configuration | Installer package
  • GCA-Pi01 | GCA-Pi02 | GCA-PI03 | GCA-PI04 | GCA-Pi05 | GCA-Pi06 | GCA107 Relay board

This example is based on the GCA145 TT/FY controller with 6 bit track addressing and position bit.

Use revision 6837+ for Turntables with Multiport interfaces in combination with RocNet.
In previous revisions the Bus variable, which addresses the RocNetNode, was not part of the commands.

Set IID and Bus according the RocNetNode to be used.

Select Single Gate for all multiport commands.