RocNetNode Servo Switch Setup

Content → Command Stations → RocNet

• RocNet Protocol | RocNetNode
  • RocNetNode Setup | RocNetNode Configuration | Installer package
  • GCA-Pi01 | GCA-Pi02 | GCA-PI03 | GCA-PI04 | GCA-Pi05 | GCA-Pi06 | GCA107 Relay board

This example shows how to setup a switch controlled by a RocNetNode servo including:

• Interface
• Field feedback (Wiring)
• Frog polarisation.

Set the bus to the RocNetNode-ID, the port type to Servo and the address to the channel on which the servo is connected.

The RocNetNode wait with generating a 'field event' until the wanted pulse width, position, has been reached.

Only set Use field events for this servo controlled switch.	The Channel Report option must be activated for this functionality.

Just set the two relay addresses for frog 1.
These addresses are most likely located on a GCA-Pi02 in combination with a GCA107.