Table of Contents
Option Switches
Content → Command Stations → Digitrax LocoNet
Digitrax uses Option Switches to setup stationary decoders. They can be set by standard switch commands or with special LocoNet commands.
Rocrail supports with this dialog reading and writing of Option Switches for the following decoders:
- BDL16x: current sensors and transponder receiver
- DS64: switches
- SE8: switches and signals
| The target decoder must be set in programming mode before option switches can be changed; See manual. |
Option Switches Dialog
Address
This is the board address of the decoder.
This address cannot be changed with this dialog, you need to check the manual for this.
Type
Select the wanted board type to program.
Option Switches List
Each board type has its own set of option switches as is listed after type selection.
Read All
Read all the option switches from the address and type set for the board.
Write All
Write all the option switches from the address and type set for the board.