Table of Contents
GCA146 Manual control for Turntable / Fiddle yard controller GCA145
A simple board
 |  |
| The finished GCA146 | Both sides of the pc-Board |
| NOTE: From Version N1.4 , the small tumbler switch and Led are no longer needed. |
The hardware files
| The schematics |
| The pcboard and parts positions |
| The bill of materials |
 with kit order, a 3D printed housing is available ask Peter |
| In present Version, S2, R17 and led are no longer used. |
|---|
| N.B. Self made pc-boards or separate ordered pc-boards are not supported! |
|---|
The previous version, MGV146 board is compatable.
All info about the MGV146 board is found here
Connection with GCA145
IMPORTANT NOTE !!!!!!
Some users seem to know better, and solder wires directly to the pins or the pc-board.!
That is totally unacceptable !!
Wires will easily break off, and cause a lot of damage in many cases.
So use connectors !!!!!
This cable is a straight connection, 8 wires, so pin1 to pin1, pin2 to pin2, etc.
Two connectors PSK 254/8W are used with 16 PSK Pins.
This special plier will be sold for net price of € 20,00 if ordered together with complete kits. 