Auto Commands

Content → Automatic Mode

• Commands

This command will enable the auto mode and set all signals, linked to a block, to red.

All locos in the list will receive a go command.

All running locos in auto mode will be send a stop request. The actual stop depends on which state the auto mode is for a certain loco. A defined stop is after the in event in a block.

This command will start all trains which were running in auto mode before the last Stop all command was issued.
In the Rocview loco pane the mode is prefixed with an asterisk if the resume flag is set.

The keyboard key Pause can be used as Emergency Stop.
An alternative solution is using a Sensor input setup with a System.Stop action.