mvtrack-setup-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| mvtrack-setup-en [2025/06/01 10:46] – [Calibrate] babbel | mvtrack-setup-en [2025/06/01 10:47] (current) – [Calibrate] babbel | ||
|---|---|---|---|
| Line 54: | Line 54: | ||
| {{: | {{: | ||
| =====Calibrate===== | =====Calibrate===== | ||
| - | If activated the selected loco will get informed of the measured kmh and will adjust its CV 5 value to match the wanted __**[[: | + | If activated the selected loco will get informed of the measured kmh and will adjust its CV 5 / CV 6 |
| Multiple runs at the highest speed step are necessary to come close to the wanted result.\\ | Multiple runs at the highest speed step are necessary to come close to the wanted result.\\ | ||
| - | Depending on the hight of the difference between Vtarget and Vactual, | + | Depending on the hight of the difference between Vtarget and Vactual, |
| If the used sensors will report a loco __**[[: | If the used sensors will report a loco __**[[: | ||
| + | This also applies when the reference block is occupied. \\ | ||
| ===none=== | ===none=== | ||
mvtrack-setup-en.1748767604.txt.gz · Last modified: 2025/06/01 10:46 by babbel