Differences

This shows you the differences between two versions of the page.

--- mvtrack-setup-en [2025/06/01 10:45] – [Calibrate] babbel
+++ mvtrack-setup-en [2025/06/01 10:47] (current) – [Calibrate] babbel
@@ Line 54: / Line 54: @@
 {{:mvtrack-import.png}}\\
 =====Calibrate=====
-If enabled, the control of the **[[#lok|selected locomotive]]** is informed about the measured km/h and the value of CV 5 / CV 6 is adjusted to match the desired __**[[loc-calibrate-en#max._km_h|Max. km/h]]**__. \\
+If activated the selected loco will get informed of the measured kmh and will adjust its CV 5 / CV 6  value to match the wanted __**[[:loc-calibrate-en#max._km_h|Max. km/h]]**__. \\
-Several runs at the respective speed step are required to approximate the desired result. \\
+Multiple runs at the highest speed step are necessary to come close to the wanted result.\\
-The greater the deviation between target and actual speed, the stronger the CV will be adjusted. \\
+Depending on the hight of the difference between Vtarget and Vactual, CV will be varried.\\
-If the used feedback sensor provides the locomotive’s __**[[:loc-gen-en#code|code]]**, the selected locomotive ID in this dialog will be overridden (RailCom, RFID, ...). \\
+If the used sensors will report a loco __**[[:loc-gen-en#code|Code]]**__ this will overwrite the selected loco ID in this dialog. (RailCom, RFID, ...)\\
 This also applies when the reference block is occupied. \\
 ===none===