Differences

This shows you the differences between two versions of the page.

--- mvtrack-setup-en [2025/05/31 07:23] – [Loco] rjversluis
+++ mvtrack-setup-en [2025/06/01 10:47] (current) – [Calibrate] babbel
@@ Line 54: / Line 54: @@
 {{:mvtrack-import.png}}\\
 =====Calibrate=====
-If activated the selected loco will get informed of the measured kmh and will adjust its CV 5 value to match the wanted __**[[:loc-calibrate-en#max._km_h|Max. km/h]]**__. \\
+If activated the selected loco will get informed of the measured kmh and will adjust its CV 5 / CV 6  value to match the wanted __**[[:loc-calibrate-en#max._km_h|Max. km/h]]**__. \\
 Multiple runs at the highest speed step are necessary to come close to the wanted result.\\
-Depending on the hight of the difference between Vtarget and Vactual, CV5 will be varried.\\
+Depending on the hight of the difference between Vtarget and Vactual, CV will be varried.\\
 If the used sensors will report a loco __**[[:loc-gen-en#code|Code]]**__ this will overwrite the selected loco ID in this dialog. (RailCom, RFID, ...)\\
+This also applies when the reference block is occupied. \\
+===none===
+Disables calibration.
+===Max:===
+Enables calibration for CV5.
+===Mid.===
+Enables calibration for CV6.
 > Note 1: The CV 5 will be adjusted by a POM write command.
 > Note 2: The CV 6 will be set by POM to 30% of the CV 5 value. (This percentage can be adjusted on the Loco Calibrate Tab.)