Differences

This shows you the differences between two versions of the page.

--- gca145-en [2025/04/03 12:14] – [Description] phg
+++ gca145-en [2025/11/21 19:25] (current) – [Connections to GCA50 / CAN-GC2 / GCA_PI02] phg
@@ Line 176: / Line 176: @@
 ===== Motorola or DCC-Control =====
-Basicly, GCA145 is made to be used with GCA50(LocoIo), CAN-GC2(CanBus) or GCA_PI02 (RocNet), when computer control is to be used.\\
+Basicly, GCA145 is made to be used with GCA50(LocoIo), CAN-GC2(CanBus) or GCA_PI02 (RocNet), aand mNY wioXX UNITS when computer control is desired.\\
 There is also a small interface available to enable digital postion control by DCC or Motorola, straight from the rails.\\
 Three ways are available.
-  *  [[http://wiki.rocrail.net/doku.php?id=mgc:gca174-en|GCA174]]     The 6 pin straight position control from GCA50(0) / CAN-GC2 / GCA_PI02
+  *  [[http://wiki.rocrail.net/doku.php?id=mgc:gca174-en|GCA174]]     The 6 pin straight position control from GCA50(0) / CAN-GC2 / GCA_PI02 / WIO-xx
   *  [[http://wiki.rocrail.net/doku.php?id=gca_lm2-en|GCA_LM2]]  The light controller for RS232 solutions. It also useable to control GCA145.
 \\
@@ Line 205: / Line 205: @@
 **
-== Cable to GCA50 / CAN-GC2 / GCA_PI02 ==
+== Cable to GCA50 / CAN-GC2 / GCA_PI02 / various WIO modules==
 refer to:  [[PSK-Interface connections-en|**Connection interfaces**]]\\
 \\
 It is possible to use MGV145 / GCA145 without any further connections.\\
-However, the first idea was to use it inside the GCA-LocoNet system, later extended in the same way to CBUS and RocNet\\
+However, the first idea was to use it inside the GCA-LocoNet system, later extended in the same way to CBUS, RocNet and a large number of various WIO modules.\\
 Therefore two connectors are available to interact with a decoder.\\
 Here follows the list of connections, when a GCA50 or CAN-GC2 is used to control.\\