Differences

This shows you the differences between two versions of the page.

--- gca145-en [2025/03/23 21:16] – created - external edit 127.0.0.1
+++ gca145-en [2025/04/03 12:14] (current) – [Description] phg
@@ Line 21: / Line 21: @@
 The position setting can be done by an incrimental switch , as known from many train speed controllers,\\
 or by means of the input connector J5.\\
-This connector can be straight connected to a [[http://wiki.rocrail.net/doku.php?id=mgv50-en|GCA50 (LNet)]], [[http://wiki.rocrail.net/doku.php?id=can-gca2-en|CAN-GC2(mergCan) I/O module]] or [[http://wiki.rocrail.net/doku.php?id=gca_pi02-en|GCA_PI02 for Raspberrry PI]] or  [[http://wiki.rocrail.net/doku.php?id=gca_lm2-en|SPL Led controller]] or from other controls systems.\\
+This connector can be straight connected to any GCA I/O decoder, like GCA50(a), GCA53, GCA500, CAN-GC2, GCA_PI01, or various WIO units.\\
 With this last option, feed-back is not possible, so that should be established in other ways.\\
 Also a fairly simple DCC- or Motorola Decoder [[:mgc:GCA174-en|GCA174]] can be used, to be able to control straight from digital rails.\\
@@ Line 29: / Line 29: @@
 Each step can be programmed, using a simple menu and the addional GCA146 control and display board.\\
 The total control unit is rather complicated, yet, through the use of a good worked out pcboard, it is rather simple to construct.\\
-Boards and /or complete parts sets are available.. Ask [[peter.giling@rocrail.net|Peter]].\\
+Boards and /or complete parts sets are available.. Ask [[peter@phgiling.net|Peter]].\\