arduino:wio-de
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| arduino:wio-de [2025/04/22 11:20] – [WIO - I/O] stefanf | arduino:wio-de [2025/05/19 20:56] (current) – [Schritt-Motor] babbel | ||
|---|---|---|---|
| Line 723: | Line 723: | ||
| | 2 | IN3 | ENABLE+ | | | 2 | IN3 | ENABLE+ | | ||
| | 15 | IN4 | - | | | 15 | IN4 | - | | ||
| - | | 25 | - | | Hall/ | + | | 25 | - | | Hall/ |
| | EP1-1 | GND | CLK-, | | EP1-1 | GND | CLK-, | ||
| | - | VCC | 12 - 45V DC | Externe Stromversorgung | | | - | VCC | 12 - 45V DC | Externe Stromversorgung | | ||
| + | |||
| + | * Der Kalibrier-Sensor sollte möglichst nahe des Gleises 0 installiert werden. | ||
| + | |||
| ===Drehscheiben-Einstellung=== | ===Drehscheiben-Einstellung=== | ||
arduino/wio-de.txt · Last modified: 2025/05/19 20:56 by babbel